Skip to content
Built at Home
48 · Flat-pack manual · 2×4 + 1×4 construction

Shoe Rack Builder

36″ × 12″ × 18¼″3 tiers · 12 pairs · $83.00
Loading model…
1
This stepDone
1
Step 1 of 7

Shopping list

Pick straight, dry 2×4s with clean edges: the legs show, and so does a bench top. For the 1×4s, common pine is fine; skip boards with loose knots or a twist you can see by sighting down the length.

ItemQtyEachTotal
2×4×8′ SPF stud (legs and side rails)2$3.50$7.00
1×4×8′ common board (slats and back aprons)6$4.50$27.00
#9 × 2½″ construction screws, 1-lb box (side rails · about 24)1$10.00$10.00
#8 × 1⅝″ wood screws, 1-lb box (slats and aprons · about 51)1$9.00$9.00
Wood glue, 8 oz1$5.00$5.00
Sandpaper, 120 grit, 5-pack1$6.00$6.00
Water-based polyurethane or porch paint, 1 qt (wet shoes ruin bare pine)1$19.00$19.00
Total$83.00

Tools: miter saw or circular saw with a speed square, drill/driver, ⅛″ drill bit for pilots, countersink, tape, combination square, two clamps.

Every cut laid onto standard boards, longest first, with a ⅛″ saw kerf between pieces. Hatched space at the end of a board is offcut, and ×3 means cut three boards the same way. Use this at the saw to cut one board at a time.

2×4 × 8′

2 boards72% yield
×12⅞″
×150⅝″

1×4 × 8′

6 boards72% yield
×123⅞″
×123⅞″
×123⅞″
×329⅞″

Width and depth are overall. Capacity counts adult pairs at 8″ a pair (9″ for boots); kids' shoes fit one more per tier. Shoe tiers have 6″ of clearance, the boot tier 14″. Stand it against a wall; anything 30″ or taller gets screwed to a stud.