Skip to content
Built at Home
46 · Flat-pack manual · ¾″ plywood construction

Garage Wall Cabinet Builder

30″ × 30″ × 12″ wall cabinet2 shelves · two doors · $156.66
Loading model…
1
This stepDone
1
Step 1 of 9

Shopping list

Sanded ¾″ plywood for the box, shelves and doors: birch, or a flat BC pine panel. Sight down the sheet before you buy; a bowed sheet makes bowed doors. The back is a ½″ 4×4 project panel, which is all this cabinet needs.

ItemQtyEachTotal
¾″ × 4×8 plywood, sanded (box, rails, shelves, doors)1$54.98$54.98
½″ × 4×4 plywood project panel (back, 30″ × 30″)1$26.98$26.98
¼″ × 3½″ washer-head structural screws (cabinet to studs: 2 per stud in the top rail, 1 in the bottom)6$0.98$5.88
#8 × 2″ wood screws, 1-lb box (box and rails, 28)1$10.98$10.98
#8 × 1¼″ wood screws, 100-pack (back, about 28)1$7.98$7.98
Wood glue, 8 oz1$4.98$4.98
¼″ shelf pins, 16-pack (8 needed)1$3.98$3.98
Full-overlay frameless cup hinges, 35 mm, soft-close, 2-pack (2 per door, screws included)2$6.98$13.96
Cabinet pull, 3″ centers2$3.48$6.96
Water-based polyurethane, 1 qt1$19.98$19.98
Total$156.66

Tools: circular saw with a straightedge guide (or table saw), drill/driver, ⅛″ pilot bit and countersink, ¼″ bit with a depth stop, 3⁄16″ bit, 35 mm Forstner bit for the hinge cups, a scrap of ¼″ pegboard (shelf-pin template), stud finder, 4′ level, square, clamps, a straight 2×4 offcut for a temporary ledger, and a helper for the lift.

Every cut laid onto standard boards, longest first, with a ⅛″ saw kerf between pieces. Hatched space at the end of a board is offcut, and ×3 means cut three boards the same way. Use this at the saw to cut one board at a time.

Sheet goods

  • A Side: 2 × 30″ × 11½″
  • B Top and bottom: 2 × 28½″ × 11½″
  • C Hanging rail: 2 × 28½″ × 4″
  • D Shelf: 2 × 28⅜″ × 11¼″
  • E Door: 2 × 29¾″ × 14⅞″
  • F Back, ½″ ply: 1 × 30″ × 30″

Rip sheet parts on a table saw or with a circular saw and a straightedge; most stores will make the first rips for free.

A ¾″ plywood box, glued and screwed, with a ½″ back glued on to keep it square and two 4″ hanging rails inside. It hangs from structural screws through the rails into at least two wall studs, never from drywall anchors. The drawing puts the underside 54″ off the floor and assumes studs 16″ on center; find your own studs first. Shelf loads are set by sag, not by the screws: see the last step.